SNMP Notification Alerts
Iotellect Network Manager provides a set of preconfigured alerts for SNMP notifications as described below.
Alert triggers can contain two conditions: for notifications of SNMP version 1, and for version 2c and above . The following table describes SNMP trap alerts and their trigger conditions.
Name | Description | Trigger Condition | |||
for SNMP Version 2c Traps | SNMP Version 1 Traps | ||||
Trap OID | Generic ID | Specific ID | Enterprise | ||
Authentication Failure | Authentication attempt failed. The source address is included in the alert message. | authenticationFailure | 4 | ||
Router Configuration Changed | Router configuration changed. | 6 | 1 | 1.3.6.1.4.1.9 or cisco | |
Cisco Fan Notification | One of the fans in the fan array fails. | 1.3.6.1.4.1.9.9.13.3.0.4 or ciscoEnvMonFanNotification | |||
Cisco Shutdown | Environmental monitor detects a testpoint reaching a critical state and is about to initiate a shutdown. | 1.3.6.1.4.1.9.9.13.3.0.1 or ciscoEnvMonShutdownNotification | |||
Cisco Temperature Notification | Temperature measured at a given testpoint is outside the normal range. | 1.3.6.1.4.1.9.9.13.3.0.3 or ciscoEnvMonTemperatureNotification | |||
Cisco Voltage Notification | The voltage measured at a given testpoint is outside the normal range. | 1.3.6.1.4.1.9.9.13.3.0.2 or ciscoEnvMonVoltageNotification | |||
Cisco Redundant Supply Notification | The redundant power supply failed. | 1.3.6.1.4.1.9.9.13.3.0.5 or ciscoEnvMonRedundantSupplyNotification | |||
Printer Alert | A critical printer event is detected. | 1.3.6.1.2.1.43.18.2.0.1 or printerV2Alert | |||
Link Down | An interface is about to enter the down state. | linkDown | 2 | ||
Link Up | An interface left the down state. | linkUp | 3 | ||
Cold Start | Cold Start, i.e. reinitializing with configuration possibly altered. | coldStart | 0 | ||
Warm Start | Warm Start, i.e. reinitializing with configuration unaltered. | warmStart | 1 | ||
EGP Neighbor Loss | An EGP neighbor for which the device is an EGP peer is down and the peer relationship no longer exists. | 5 |
Custom alerts for SNMP traps can be easily created by users for their specific needs using the described alerts as examples.
Was this page helpful?